作者： Amir Maghsoudi^a. FatemehYazdian^b. Saleheh Shahmoradi^b. Leila Ghaderi^b. Mehran Hematic. Ghassem Amoabediny^d.

^a Department of Industrial Biotechnology, National Institute of Genetic Engineering and Biotechnology, Tehran, PO Box 14965-161, Iran

^b Department of Life Science Engineering, Faculty of New Science and Technologies, University of Tehran, Tehran, Iran

^c Research and Entrepreneurship Center, Amirkabir University, Tehran, Iran

^d Department of Chemical Engineering, Faculty of Engineering, University of Tehran, Tehran, Iran

 

摘要：Curcumin was loaded into different polysaccharide nanoparticles chitosan, alginate and starch, using the desolvation method. Curcumin-loaded nanoparticles exhibited enhanced solubility in aqueous solutions comparing with free curcumin. Effects of formulation parameters such as curcumin concentration and different volumes of ethanolic solution were affected the particle size and loading efficiency. Under optimum conditions, curcumin-loaded chitosan, starch and alginate nanoparticles with mean particles sizes of 66.3, 61.1 and 78.8 nm, and maximum loading efficiencies of 11.9%, 14.3% and 13.35% were achieved, respectively. Additionally, the minimum inhibitory concentration for chitosan, starch and alginate nanoparticles against the microorganism, Streptococcus mutans, were 0.114, 0.204 and 0.204 mg/mL, respectively. Curcumin was observed to release from nanoparticles under physiological pH over a period of 96 h. The effect of curcumin-loaded nanoparticles on S. mutans biofilms was assessed on dental models. According to the results, curcumin-loaded chitosan nanoparticles hold promises for being used in dental decay fighting products.