鲍米勒伺服驱动器维修服务：719：Timeout during motor identification电机识别超时。Error during identification of motor parameters. The maximum permitted phase voltage (= 80 V) was exceeded during the resistance measurement.识别电机参数时出错。在电阻测量过程中，超过了每个允许相的最大电压（=80V）。

Possible cause: 原因：

Incorrect motor nominal current setting in Parameter 107.09.

参数107.09中的电机标称电流设置不正确。

Effect: Output voltage set to ZERO to protect the motor. An additional drive block occurs with standard error response.

效果：输出电压设置为零，以保护电机。附加的驱动器块出现标准错误响应。

Resetting after error elimination: 错误消除后重置：

Error reset is possible. Timeout (45 seconds) with R measurement with motor parameter identification, such as due to error during current / voltage measurement or normalization or limit value.错误重置是可能的。电机参数识别的R测量超时（45秒），例如由于电流/电压测量或标准化或限值过程中的错误。