SSP-KONSTANTER

销售：钟 ：

SSP-KONSTANTER, Series SSP 120 / 240 / 320

SSP 120 /SSP 120/SSP 120/SSP 320/SSP 320/SSP 320/SSP 240

Laboratory Power Supplies

The SSP KONSTANTER series (single output system power supplies) includes programmable, voltage and current regulated DC power supplies with 120 W, 240 W or 320 W of output power. They include a ìP-controlled operating system and are furnished with an addressable RS 232C serial interface as standard equipment. Up to 30 instruments can thus be controlled from a single PC port. An IEEE 488 interface can be optionally integrated. Both PC interfaces allow for complete control of all instrument functions, and support the querying of measurement values, set-up parameters and instrument conditions.

Manual adjustment of voltage and current is accomplished with two rotary pulse generators with adjustable resolution. Two 4-place multifunction displays allow for the accurate read-out of measurement values (V, A, W), as well as menu-driven parameter adjustments for a multitude of additional functions such as setting range limitation, overvoltage protection, delayed overcurrent shut-down or programmable digital signal inputs and outputs.

Up to 243 settings can be stored to memory and can be recalled either individually or sequentially, e.g. for the generation of specific current or voltage sequences. The advanced circuit technology is capable of essentially load-independent response times of less than 1 ms. The output parameters can thus be superimposed with AC signals with values up into the kHz range with the analog interface which is furnished as standard equipment. The measuring function is equipped with an extreme value memory, limit monitoring signals and a hold function.

• Very short response times thanks to BET technology (bidirectional energy transformation)

• Auto-ranging output with 120 W, 240 W or 320 W

• Output power is doubled in short-time operating range

• Minimum residual ripple

• Very good dynamic control parameters

• Addressable RS 232 interface / analog interface as standard equipment

• Optional IEEE 488 interface

• Integrated sequence function for the generation of automatic voltage and current sequences

• Calibration procedure for menu-driven balancing

• Output ON / OFF function

• Output terminals at front and rear panels

• Master-slave operation for parallel and series connection

• Protection against overvoltage, overcurrent and excessive temperature

• Minimal power loss