Delivery System 小容量输送系统SVDS2

Delivery System 小容量输送系统SVDS2

Delivery System 小容量输送系统SVDS2

小容量输送系统SVDS2，用于标准15ml管，来自

萨斯特德。该系统采用8根锥底小塑料管和薄聚四氟乙烯管连接

你的设置。带有溶液的管子只需拧入保持架即可。解决方案很容易在

实验。可用于微型歧管、灌注系统和压力控制器。要求

加压气体输送溶液。也可以使用控制流量或真空来提取溶液

系统。可用于抽吸取样。

该系统配备了所有必要的管道和配件，以连接到一个单一的压力源。小尺寸

200x25x25mm（不带管）可将溶液放置在样品附近。可以附加到

一根1英尺长的杆（包括在内）。带有X形块，可连接到标准0.5英寸。站起来。包括可更换塑料

15ml管、聚四氟乙烯管、接头和连接到压力源的管

所提供的配件允许您将导管直接连接到灌注系统的阀门，并从

直接连接到阀组或定制管道和阀室的阀门。我们所有的流形都可以连接，包括

零死容量，luer锁和微型单细胞灌注管汇。如图所示，是

SVDS2系统连接到PS-8H设置的夹管阀。SVDS2的输出然后进入ZMM流形

在培养皿内提供液体输送和溶液交换，培养皿内插入PDI。流出

通过MTH-S支架的吸入管提供。物品#：SVDS2

 Small Volume Delivery System SVDS2 For use with standard 15ml tubes from
Sarstedt. This system utilizes eight small plastic tubes with conical bottom and thin PTFE tubing to connect
to your setup. Tubes with solutions are simply threaded into the holder. Solutions are easy to refill during the
experiment. Can be used with miniature manifolds, perfusion systems, and pressure controllers. Requires
pressurized gas to deliver the solutions. Solutions can be also withdrawn using controlled flow or vacuum
systems. Can be used to collect samples by aspiration.
The system comes with all necessary tubing and fitting to connect to a single pressure source. The small size
of 200x25x25mm (without tubes attached) allows to position solutions near your sample. Can be attached to
a 1 ft. rod (included). Comes with X-block to attach onto a standard 0.5 in. stand. Includes replaceable plastic
tubes 15ml, PTFE tubing, fitting and tubing to connect to a pressure source
Provided fitting allows you to connect tubes directly to valves of perfusion systems, and the output from
valves directly to the manifolds or custom tubing and chambers. All our manifolds can be connected, including
zero-dead volume, luer-lock, and miniature manifold for single cell perfusion. Shown on the picture, is
SVDS2 system connected to the pinch valves of PS-8H setup. Output from SVDS2 then goes to ZMM manifold
to provide liquid delivery and solution switching inside a Petri dish with PDI insert inside. The outflow
is provided through a suction tubing of MTH-S holder. Item#: SVDS2

 注：杨清辰发布