Zero-Dead Volume Manifold, ZMM

Zero-Dead Volume Manifold, ZMM

Zero-Dead Volume Manifold, ZMM

零死体积流形

零死容量有助于小容量灌注室内的溶液交换。输出通道

可在不同高度调节，防止溶液污染。较低的输出

例如，浓缩溶液的位置可以更高，这样它们就不会与其他溶液混合

解决。上部通道也可用于从小体积中抽吸多余的溶液

灌注室。

内置的磁性支架允许您将歧管放置在样品周围的任何位置。二

拇指螺钉将歧管固定在所需位置：高度、角度、长度。配有2英尺长的特氟龙

管道，连接至聚酰亚胺250/360微米内径通道。所有管道都是可更换和可清洗的。

需要灌注系统或/和加压小容量输送系统SVDS1。可与

小容量PCCS2、CSC室和培养皿插入物。考虑使用微孔管接头PS套件。

船上配置了六个360微米的通道，允许你做从1到6通道的歧管。

是否需要8通道250微米内径通道。项目#：ZMM

•通道：可拆卸6通道，360微米

•连接管：包括2ft.管

每个通道，带luer连接器

Zero-dead volume facilitates solution exchange inside small volume perfusion chambers. The output channels

can be adjusted at a different height to prevent contamination of solutions. The outputs for lower

concentration solutions, for example, can be positioned higher so that they do not mix with other

solutions. The upper channels can be also used to provide suction of excess of solution from small volume

perfusion chambers.

Incorporated magnetic holder allows you to position the manifold anywhere around your sample. Two

thumb screws fix the manifold in required position: height, angle, length. Comes with 2 ft. long Teflon

tubing, attached to polyimide 250/360 micron I.D. channels. All tubing is replaceable and washable.

Perfusion system or/and pressurized Small Volume Delivery System SVDS1 is required. Can be used with

small volume PCCS2, CSC chambers and petri dish inserts. Consider microbore tubing fitting PS-kit.

Ships configured with six 360micron channels, which allow you do make from 1 to 6-channel manifolds.

Specify if 8-channel 250 micron I.D. channels are required. Item#: ZMM

• Channels: removable 6-channel, 360 micron

• Connecting tubing: incorporates 2ft. tubing

per channel, with luer connector

注：杨清辰发布