TESEQ CBA 3G-300 *固态功率放大器

按照*、线性、低失真性功放要求设计采用高可靠性的砷化镓半导体技术具有*的失配容差和*的稳定性高带宽特性远程控制选项

Designed specifically for radiated EMC testing, this mismatch tolerant class A amplifier delivers power continuously into the poor and variable match typically associated with testing above 1 GHz. Although antenna are usually well matched at these high frequencies, the presence of the EUT in the path of the antenna causes high levels of reflected power which only fully class A amplifiers can handle.Although antenna gain is relatively constant, increasing cable losses at the higher frequencies demand increasing power with increasing frequency. Teseq amplifiers are therefore designed to maintain their high linear output power right up to and beyond the defined frequency range. This amplifier will produce usable power up to 3.2 GHz, the power level is not defined but is typically around 200 Watts. The GaAs class A design ensures a high reliability, low distortion linear performance across the frequency range. This design also ensures that the amplifier will continue to operate at full power even when presented with an open or short circuit at its output. The unit is powered from a switched mode power supply for high efficiency, high power factor and wide voltage range operation. The unit is air-cooled with integral fans, and is protected against faulty cooling by excess temperature sensing. A safety interlock connector is provided, which the user can short circuit to ground, to put the amplifier into standby mode. Front panel indicators are provided to indicate over-temperature and rf interlock condition.

Frequency range (instantaneous) 800 to 3000 MHz >3000 to 3100 MHzRated output power 300 W 225 W minimum 350 W 250 W typicalOutput power at 1 dB gain compression 290 W 200 W minimum 325 W 225 W typicalGain (nominal) 56 dBThird order intercept point (see note 1) 65 dBmGain variation with frequency ±4 dBHarmonics at 290 W output (800 MHz to 3 GHz) Better than -20 dBcOutput impedance 50 OhmsStability UnconditionalOutput VSWR tolerance (see note 2) Infinite:1Input VSWR 2:1RF connector style Input Type N female Output Type N femaleSafety interlock BNC female, s/c to muteUSB interface OptionalSupply voltage 184 to 264 Vac (phase to phase for Delta (Δ) or phase to neutral for star (Y)) (see options for three phase configuration)Supply frequency range 45 to 63 HzSupply power<3 kVAMains connector Appropriate IEC 60309 plug (see options)Conducted and radiated emissions EN 61326 class AConducted and radiated immunity EN 61326: 1997 table 1Mains harmonic currents EN 61000-3-2Voltage fluctuations and flicker EN 61000-3-3Safety EN 61010-1Case dimensions 19 inch, 34U rack, 800 mm deepMass 150 kg Operating temperature range 0 to 40°COptions (select at time of ordering)341-823 Three phase plus P.E. delta connection no neutral (4 pin plug)341-923 Three phase, neutral plus P.E. star connection (5 pin plug)341-999 USB Interface (Remote control of standby/operate. Interlock and fault mode monitoring)

TESEQ CBA 3G-300 *固态功率放大器

深圳市美佳特科技有限公司（简称“美佳特"）成立于2010年，致力于光通讯测试、通用电子测量及5G测试服务。美佳特以“无线沟通，沟通无极限 "企业使命，业务聚焦于精密测试测量仪器的租赁、销售、维护、计量及测试环境搭建等一站式服务。N2843A Keysight 无源探头 Keysight 是德

主营产品：示波器主机和模块、眼图仪、光谱仪、信号源、频谱分析仪、网络分析仪、阻抗分析仪、光通信仪器、误码仪、光时域反射仪、可调谐激光源、光功率计、光衰减器等。合作品牌：安捷伦、是德、泰克、安立、爱得万、安腾、力科、马可尼（IFR）、R&S、EXFO等。N2843A Keysight 无源探头 Keysight 是德

主推：Agilent 86100D/C 示波器,keysight M8195A 任意波形发生器,Anritsu MS9740B/A 光谱分析仪,YOKOGAWA AQ6370D/E 光谱分析仪,keysight N1092A/C 采样示波器,keysight E8257D 模拟信号发生器,keysight E5071C 矢量网络分析仪